Polyethylene C-Clamp® and Sealing Rods can be cut to any length. To make an airtight, leak-proof seal, place the C-Clamp®, open side up, on a clean, hard surface. Wrap the open bag end once over the round plastic sealing rod and push the rod down into the "C" shaped opening of the C-Clamp®, inserting the middle of the rod first, then moving outward toward each end. We recommend ordering C-Clamp® Sealing Kits at least 1" longer than the length of the bag end to be sealed. The Rod in each unit (more
Unit of Measure

Note

N/A Now available in 3 width sizes.

Additional Information

N/A

  • Rod Diameter: 3/8"
  • For Bag Length: 1" to 39"
  • To order "C" Clamp sealing kits in multiples of 1", add "X" and the number of inches to the end of the Catalog No.
  • For example: 27" long "C" Clamp, 3/8" rod diameter = Catalog No. CPSBAGS-138X27.

Specifications

C®-Clamp Length

 1 to 47 in

Nominal Rod Diameter

 1/8 in

Rod Length

 2 to 48 in

Minimum Order Quantity

 1

Suggestion

N/A

  • Before use, thoroughly flush bags with ultra-pure nitrogen or zero air
  • During sampling, Fluoropolymer tubing and Fluoropolymer faced septums must be used in order to prevent sample loss.
  • Bags should not be filled to more than 80% of their maximum volume.
  • Charcoal (Black) Tedlar® bags should be used when sampling light sensitive compounds
  • Do not store compounds in bags long term due to the possibility that chemicals may adsorb onto the bag surface.
  • Bags should not be used to collect reactive or unstable compounds.
  • When shipping bags, do not air-ship unless the bags are stored in a pressurized area.